For instructions on how to install a new garage door opener see how to install a garage door opener.
Torsion bar garage door installation instructions.
Roller track support brackets and the opener should be securely bolted to the rafters.
Supplemental instructions torsion spring installation this is a supplement to the residential garage door instructions referred to as the manual.
Installation of rear torsion spring system.
When two springs are used both sides should be adjusted the same.
Finger tighten nuts on bolts until the stationary cone is flush against the center bearing plate.
After the springs are installed proceed to page 6 step 35 of the door installation instructions to finish the installation.
For extension spring installation go to page 7 of these instructions.
Follow the track bolt placement figure.
Read the information in both.
With locking pliers clamped on the torsion tube winding bars are used to wind the springs tighter to increase tension.
Tension is reduced by removing turns.
Torsion springs 1 6 19 w a r r a n t y 3 1 read this manual carefully and observe all warnings when installing operating or maintaining your garage door.
Make sure that the bearing is inside the stationary cone.
It covers installation of torsion springs step 14 of the manual.
Insert the bolts in the stationary cones of the new torsion spring and insert the bolts in the slots on the spring anchor bracket.
In the end scott got the door that he wanted installed along with a great liftmaster garage door opener.
Torsion spring brackets should be firmly mounted to the wooden header above the door.
8 align the lhr rear upper track to the standard track so that the gap between the lhr front and lhr rear upper tracks is not greater than 1 8.
For torsion spring installation go to page 7 of the door installaton instruc tions.
To adjust torsion spring tension the door is locked in the down position.
Securely mounted hardware and rails.
Adjustments should be made in 1 4 turn increments.
For all other information and safety warnings concerning your garage door see the manual.
Mark the position on the standard track through the lower hole in the front splice plate connected to the lhr rear upper track.
Steel residential garage door installation instructions and maintenance 1 and 2 layer construction in this manual you will find safety information how to prepare the opening installing the new door painting maintenance and replacement parts.